This remodeling account will send receiver replacement remodeling of… “MINIUM Plain 3ch Super decathlon”. Though a heart made acquisition of a fuselage out of print be excited, I met with a test flight, but you sprained a projection part because of a problem of the radio reach. A radio wave kept not understanding the cause and running after the fuselage which is a free No condition and falls at the beginning. While repeating a fall and a forced landing several times, because control isn’t lost when the distance is close, it’s judged as a radio wave arrival problem. It’s useless, you can’t skip directly, so I’ll replace a receiver…. Receiver replacement 3ch receiver of MINIUM plain is a world’s first integrated receiver equipped with 2 straight servos. “thing good” of DSM2 interchange where a substitution receiver is “Micron MX-RX62H” of HobbyKing sale and is equipped with 2 straight servos. To do linkage juncture of a servo for rudders in an aileron primarily, a receiver of standard loading is the peculiar structure loaded slantingly. An aileron moves to the main plane back as well as a linkage arm to load the servo which became independent. A rudder and an elevator are ordinarily connected, so a level pedestal is produced by styrene and it’s loaded on it. 31.6 grams of 33.5 grams of⇒ succeeds in realization of DSM2 and 4ch-ization only by 1.9g increase after remodeling before remodeling. Flight test The flight which can be a fuselage though a maiden makes the 1st a trim adjustment by an example. A trim adjustment has also ended, so it’s flight test starting. I rise lightly and it’s apart from land, no, thank you. It was also a remark in the picture, but though a battery charges it fully, a power sense is a little thin. Degradation of a battery-? It isn’t to the extent I have an influence on a flight test, so it’s continued. From the place where this time redoes the value as 3ch aircraft which is originally without using a rudder as much as possible. First, loop from a level flight. The driving force is enough. It can’t be drawn, but a big loop will be a pass point as a micro chance. The next is the roll. The roll on the other side. It’s only aileron steering, but the height falls a little, but I finish going around beautifully by the high roll rate. The end releases tying of rudder nonuse, and 4ch is full and tests a flight. Even if a full down is applied, the back is descending. The stability is also bad. Slow fry is liked, I’m weak and unsteady in a wind. On which a crosswind is severe! A landing succeeds somehow. Summary
I faced a problem of the radio reach last time and replaced a receiver by the revenge it wasn’t possible to transfer completely. RTF sale of a set is general to a transmitter in the world of UltraMicro aircraft.
A transmitter of a tape measure course can’t be used because the receiver-transmitter of those RTFs is low performance, and most cases isn’t compatible by an original protocol made by manufacturer. All protocols are different and are the chaos to which a transmitter isn’t compatible by 3 kinds, 3ch plain series, a AD series of 4ch and alpha series as for MINIUM. It was an intelligent period of 2.4GHz but how much is… cruel? Now, the fuselage which replaced a receiver by the “MicronMX-RX62H” familiar by a remodeling account of this channel showed original flight performance and made them feel good of the feature. The back is difficult by a cause of a camber wing, but taking off and landing can enjoy the roll and a loop without anxiety and highly precise control is possible, so isn’t also difficult.
There is no reserve capacity in a driving force, but it’s recommended by the remodeling which can achieve the fuselage even an expert can enjoy from a beginner. Thanks for watching.